CTM Lyng mKomfy_Sensor

   
Model mKomfy_Sensor
Vendor CTM Lyng
Description mKomfy, stove guard
Exposes battery, battery_low, temperature, alarm_status, active, linkquality
Picture CTM Lyng mKomfy_Sensor

Options

How to use device type specific configuration

  • temperature_precision: Number of digits after decimal point for temperature, takes into effect on next report of device. The value must be a number with a minimum value of 0 and with a with a maximum value of 3

  • temperature_calibration: Calibrates the temperature value (absolute offset), takes into effect on next report of device. The value must be a number.

Exposes

Battery (numeric)

Remaining battery in %, can take up to 24 hours before reported.. Value can be found in the published state on the battery property. It’s not possible to read (/get) or write (/set) this value. The minimal value is 0 and the maximum value is 100. The unit of this value is %.

Battery_low (binary)

Indicates if the battery of this device is almost empty. Value can be found in the published state on the battery_low property. It’s not possible to read (/get) or write (/set) this value. If value equals true battery_low is ON, if false OFF.

Temperature (numeric)

Measured temperature value. Value can be found in the published state on the temperature property. It’s not possible to read (/get) or write (/set) this value. The unit of this value is °C.

Alarm_status (enum)

Alarm status.. Value can be found in the published state on the alarm_status property. It’s not possible to read (/get) or write (/set) this value. The possible values are: ok, tamper, high_temperatur, timer, battery_alarm, error, unknown.

Active (binary)

Stove guard active/inactive (Stove in use). Value can be found in the published state on the active property. It’s not possible to read (/get) or write (/set) this value. If value equals true active is ON, if false OFF.

Linkquality (numeric)

Link quality (signal strength). Value can be found in the published state on the linkquality property. It’s not possible to read (/get) or write (/set) this value. The minimal value is 0 and the maximum value is 255. The unit of this value is lqi.