Lonsonho QS-Zigbee-C03

   
Model QS-Zigbee-C03
Vendor Lonsonho
Description Curtain/blind motor controller
Exposes cover (state, position), moving, calibration, motor_reversal, calibration_time, linkquality
Picture Lonsonho QS-Zigbee-C03

Options

How to use device type specific configuration

  • invert_cover: Inverts the cover position, false: open=100,close=0, true: open=0,close=100 (default false). The value must be true or false

Exposes

Cover

The current state of this cover is in the published state under the state property (value is OPEN or CLOSE). To control this cover publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"state": "OPEN"}, {"state": "CLOSE"}, {"state": "STOP"}. It’s not possible to read (/get) this value. To change the position publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"position": VALUE} where VALUE is a number between 0 and 100.

Moving (enum)

Value can be found in the published state on the moving property. It’s not possible to read (/get) or write (/set) this value. The possible values are: UP, STOP, DOWN.

Calibration (binary)

Value can be found in the published state on the calibration property. To read (/get) the value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get with payload {"calibration": ""}. To write (/set) a value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"calibration": NEW_VALUE}. If value equals ON calibration is ON, if OFF OFF.

Motor_reversal (binary)

Value can be found in the published state on the motor_reversal property. To read (/get) the value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/get with payload {"motor_reversal": ""}. To write (/set) a value publish a message to topic zigbee2mqtt/FRIENDLY_NAME/set with payload {"motor_reversal": NEW_VALUE}. If value equals ON motor_reversal is ON, if OFF OFF.

Calibration_time (numeric)

Calibration time. Value can be found in the published state on the calibration_time property. It’s not possible to read (/get) or write (/set) this value. The unit of this value is S.

Linkquality (numeric)

Link quality (signal strength). Value can be found in the published state on the linkquality property. It’s not possible to read (/get) or write (/set) this value. The minimal value is 0 and the maximum value is 255. The unit of this value is lqi.